As flushing the cooling

As flushing the cooling

Flushing your cooling system is one of the easiest projects you can undertake. It should help a part of your regular maintenance schedule to ensure that the cooling system will always work properly.

Here's what you need:

* A flat-blade screwdriver

* A Pan without coolant, the catch from

* A garden hose

Step One: Make coolant

Most radiators have a small wing nut at the bottom of the radiator. You must enter your skilletbegin under the radiator coolant and open the drain valve.

Once these valves may have liquid cooling, as far as possible, you have the lower radiator hose and disconnect it from the radiator. This allows you to do the rest of the liquid cooling system.

Step Two: The Flushing

Reconnect the lower tube and close the drain valves. Then you put a garden hose at the top of the radiator and let the water flow. Give it to irrigate about 15 minutes withoutDirt, dust, rust or old coolant from the cooling system. This is also a good time to check for leaks.

Step three: put in new coolant

Make sure you buy a good pre-made mixture of 50 percent antifreeze and 50 percent water. Cap everything off with a little more water if you are short.

** NOTE ** Make sure the engine coolant is above a cold wire. The refrigerant can be very hot if the engine is running for a while '. It would be a good idea to cool the vehicleOpen for a couple of hours before this project.

The pressure that builds up can also be dangerous to the radiator. You can burn from the hot coolant when they released while under pressure. There is also a good idea to help a pair of gloves for this project, and some sawdust to clean up spilled antifreeze invest funds.

** Please Note ** refrigerant used in a closed container. And 'illegal and harmful to your neighborhood, to leave an open container.

Crestview Collection Table Lamps rapida pressure cooker parts