1. Lift the car up. If you do not have one, ramps or elevators to use a socket. Take the back, so get in a position under him. Assess the shape of all parts of the exhaust system prior to departure. If you want to start the catalyst, exhaust manifolds, or the crossover pipe, make sure you have the necessary parts before you order the Los old drainage system.
2. Lie on your back and place themselves under the car until you look at where the pipesthe catalyst.
Exhaust System
3. Remove the old exhaust system from the rear of the machine and make your way forward. Typically, the screws are rusty and difficult to remove if you do not have a weapon impact. Apply to penetrate a bit 'of WD-40 screws.
4. Remove all components of the exhaust system that is being replaced. Take them out of the trailer and put aside your party. Now you should remove all of the line. If you are brand new trailer (proposed as stock are those spongyand old), cut the old work with any type of cutting tool (a Dremel).
5. Depending on the type of hook that you put on your car, a brand-new clothes on the outlet tube pieces first, which is usually a less complicated method, put the pieces back.
6.Beginning from the front of the car, install the exhaust pieces and then put it on the tube in front of her. Do not wear it all the way until you have all the pieces.
7. If you do not have brandnew gasket in position between the pipe sections, or buy some new or you can use the old, if they have the right diameter. It is recommended to avoid further losses have followed.
8.Subsequently are connected to all cylinders to start the assembly of each part to 1. Apply a sufficient amount of torque each screw to make sure it is tight.
9. If you made it to the back of the car, take a few steps back and correct alignmentChanges. They want the tailpipes flush with the bumper and look satisfactory.
10. Check all bolts and make sure they are tight.
11. Start the car and you find there were any holes.
As Cat Back Exhaust System
No comments:
Post a Comment